Archive

Posts Tagged ‘mobile’

When terminations go bad…

December 15th, 2010 No comments

Found this mess in a lighting control panel last week. These type of crimp on terminal connectors don’t work on solid wire.

12 unit meter bank change out

December 15th, 2010 No comments

We just completed this project last week. Retro fit of a new 800 amp service on a 12 unit building. The old service was not installed correctly and failed due to water and rust.

We do Kiln Installs!

December 15th, 2010 No comments

We have worked with many of the potters in the area for kiln installs and repair work. We did this install with vent a few weeks ago.

Generator cords for Fowler Ridge wind farm

December 15th, 2010 No comments

Made up these 300′ extension cords this week. 30 amp / 240 volt with twist lock ends and strain relief grips. These will be used to drop down the towers while they are under construction.

New 200 amp service – the Artisan Way

December 15th, 2010 No comments

This is a picture of a new 200 amp service done the Artisan Way!

Electrical Tip of the Day – Fall outdoor light fixture maintenance

October 13th, 2010 No comments

Its that time of year again and (gasp) bad weather will be upon us soon.  This weeks tip is a simple one… it will save you a bundle to deal with outdoor light fixture repairs before the snow flies and things freeze… in some case, like in ground landscape lighting, if a problem occurs after it has hard frozen for the winter we have little choice but to put the repair work off until spring thaw

In other areas, like commercial parking lot lights, wall packs, those pesky motion detector sensor lights – getting fresh lamps in and checking out the systems before winter is money well spent.  Things break when it gets cold, and planning for bucket truck / large ladder use during those bad winter months will always cost more then doing the same work during favorable weather.

And of course – PLANNED maintenance is always more cost effective then emergency or unplanned repair work!